Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
How to install ADSS optical fiber cable ?
Once the slack is removed install a temporary deadend on the cable approximately 2 deadend assembly lengths away from the support pole. This deadend will be used as a tensioning grip to achieve proper span sag and tension prior to installing the permanent deadend assembly.
8.4 Attach the tensioning device: a chain hoist or power winch and a dynamometer between the pole and the temporary deadend. Begin to apply tension to the span.
8.5 The cable is normally tensioned from deadend to deadend along the span back to the reel. Once the spans are properly sagged and deadends attached, the suspension or tangent hardware is installed and attached to the poles by working back to the deadend one span at a time.
8.6 Once the permanent deadends are installed and the hardware attached to the poles, the pulling device can remove the tension and the temporary deadends removed from the cable. When the next permanent deadend is installed on the adjacent span, make sure the loop formed between the two deadends maintains the minimum bend radius for the cable. Repeat this operation until all spans are sagged and tensioned.......
As we all know, multimode fiber is usually divided into OM1, OM2, OM3 and OM4. Then how about single mode fiber (SMF)? In fact, the types of single mode fiber seem much more complex than multimode fiber. There are two primary sources for the specifications of single mode optical fiber. One is the ITU-T G.65x series, and the other is IEC 60793-2-50 (published as BS EN 60793-2-50). Rather than referring to both ITU-T and IEC terminologies, we'll only stick to the simpler ITU-T G.65x in this article. There are 19 different single mode optical fiber specifications defined by the ITU-T, among which G.652 fiber is the most commonly used.