Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
How to install ADSS optical fiber cable ?
The maximum span distance and maximum angle/degree of offset specified by the hardware supplier should not be exceeded. The maximum angle of change is typically 20 degrees; however, this is limited to 10 degrees if the cable is pulled through the tangent support. Note that cable cannot be pulled through suspensions.
Suspensions: Suspensions are also installed after the span has been tensioned. Suspensions are hung from the pole using shackle. The maximum angle of change for suspensions is typically 30 degrees. Suspensions without support rods
should not be used on span exceeding 600 feet. Suspensions with support rods may be used on spans up to 1200 feet.
Armor Grip Suspension (AGS): Used for any span length with an angle change, either horizontal or vertical, less than 30°. An AGS Suspension or Suspension with support rods shall be used for in-line structures if the span is greater than 600 feet. Suspensions with support rods are limited to 1200 feet.