Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
How to install ADSS optical fiber cable ?
All slack cable storage locations require the installation of cable storage brackets. The cable storage bracket insures the proper bend radius for the stored fiber optic cable and provides for horizontal storage and tiering of multiple cables and loops.
Figure 5 below illustrates slack cable storage.
Figure 5 - Cable Slack Storage
7.0 CABLE SUPPORT HARDWARE
There are two general types of ADSS cable support hardware: dead ends and tangent assemblies. Hardware manufacturer's installation instructions should take precedence over the guidelines below. Note the selection of hardware depends on the cable diameter and span distance. The selection of dead-ends also depends on the maximum installation tension and maximum rated cable load. PLP is the recommended hardware supplier.
7.1 Deadend assemblies are normally used at the point of cable termination or where the cable angle is greater than 30°. See Figure 6 below for illustration of a Deadend Assembly.