Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
More Academical knowledge for optical cables and cores :
ADSS cable is pulled through the entire section using the puller and tensioner. Care must be taken to avoid over tensioning the cable as well as excessive sagging which may introduce bends smaller than the minimum bend radius. Several pulling stages may be required to place the cable through the entire system.
5.1.5 Once the entire cable has been pulled into place, each dead-end to dead-end section can be sagged and tensioned and support hardware applied accordingto the installation requirements.
Figure 2 - Incorrect Traveler Figure 3 - Correct Traveler 10
5.2 The Drive-off method is illustrated in Figure 4 below:
Figure 4 - Drive Off Method of Cable Deployment
5.2.1 The Drive-off Method of cable placement is primarily used during the construction of new lines where there is a clear right-of-way and with noobstructions to vehicles.
5.2.3 The reel of cable is placed on a reel trailer or a truck equipped with a reel carrier. The cable should pay off the top of the reel for reel trailers and the bottom of the reel for trucks equipped with a reel carrier. The reel trailer or reel equipped truck should have a braking device, set on minimum. The brake is used to prevent overrun of the reel when stopping at the support poles.
Name Other Names Specified Wavelength (nm) Applications
G.652 Zero-Dispersion/Non-dispersion-shifted fiber, or standard SMF. 1310, 1550, 1625 (C and D excluded) LAN, MAN, access networks and CWDM transmission.
G.653 Dispersion-shifted optical fiber 1310 to 1550 Long-haul single-mode transmission systems using erbium-doped fiber amplifiers (EDFA).
G.654 Cut-off shifted optical fiber 1550 Higher bandwidth submarine systems and back haul systems.
G.655 Non-zero dispersion-shifted optical fiber (NZDSF) 1550 to 1625 Long-haul systems that use Dense WDM (DWDM) transmission.
G.656 Non-Zero dispersion for Wideband Optical Transport fiber 1460 to 1625 Long-haul systems that use CWDM and DWDM transmission over the specified wavelength range
G.657 Bending loss insensitive optical fiber for access networks 1260 to 1625 Fiber-to-the-home (FTTH) networks.