Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
Please note if the pulling tension is greatly reduced during a pull, the natural sag of the cable will usually produce angles larger than 20 degrees at each support point. Thus, extreme caution must be used if pulling through small diameter supports.
Traveler Installation: Each structure in the pulling segment must have a traveler installed and a pulling rope threaded (reeved) through it. Each traveler must be balanced so that the rope, and the following ADSS cable, ride at the bottom of the neoprene insert's groove. It is important to tie up the traveler at each angle so the pulling rope and ADSS cable enter and exit the traveler smoothly (See below Figures 2 & 3). If the cable enters at an angle, it increases the chance of jumping from the traveler groove into space between 9 the traveler and the yoke holding the traveler to the pole. This would cause severe damage to the cable.