Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
Academical description: The travelers or sheaves are normally attached directly to the support pole. The pole attachment hardware must be consistent with the working load and rating of the travelers and sheaves.
6.4 The pulling grip shall be rated above the maximum anticipated pulling tension. Follow the manufacturer's installation instructions. When properly installed, no special preparation of the cable end or aramid yarns is required. A matching
clevis type swivel should be used to help prevent twisting of the cable during pullin. The swivel should be of the type that has a break-away tension less than the cable's rated maximum pulling tension to prevent over tensioning.
6.5 Aeolian vibration is a resonant vibration caused by low velocity wind blowing across a cylindrical cable under tension. This vibration can cause severe degradation of the support hardware. Vibration dampers can be very effective in controlling Aeolian vibration on ADSS cable. Both resonant and interference type vibration control systems will work when properly applied.
6.6 Splice locations require additional cable to accommodate lowering to the ground with enough slack to allow splicing inside a splicing van or trailer.
Single Mode Fiber Connector Types
A fiber optic connector terminates the end of a fiber optic cable. A number of fiber optic connector types have been evolved and withstood the test of time to become industry standards. The main types of single mode fiber connectors include: ST, FC, SC, and LC. Get more details about commonly used fiber optic connectors here: Fiber Optic Connector Types, Market, & Installation
The use of single mode fiber optical cable is the best way to get rid of modal dispersion over long distance. So it is very popular to be used in backbone systems, and a number of large companies use SMF cables to wire up an entire building or a corporate office. Compared to multimode fiber cable, these fiber patch cords are future-proofing and an effective way to save money on the hardware by purchasing these cables in bulk.