Fiber Cable Manufacturer
ADSS Aerial Fiber Optic Cable 1-144 core
Cores available: 2,4,6,8,12,24,32,36,48,64,72,96,128,144.
Span: 50,100,150,200,250,300,400,500,1000 meters
Applications: Aerial networking system
Jackets: PE, HDPE,AT
Jackets layers: inner jacket+outer jacket.
Multi modes: OM1,OM2,OM3,OM4
Single mode G652D,G655C,G657A1,G657A2
Package:1km/2km/3km/4km each reel.
Do not cut the cable under any circumstances without prior approval of the engineer responsible for the project. Splice locations are determined in the initial system design by the project engineer. Introducing new splices can potentially degrade the transmission characteristics of the system.
2.9 Temporary or permanent guys should be installed at any location where the self supporting cable is tensed to avoid placing an unbalanced load on the support poles.
2.10 Wire mesh grips are intended for pulling the cable into place and are not intended for strength the cable in place. Do not use split wire mesh grips to tension or to hold cable under tension.
2.11 All safety practices of the Power Utility and the Installation Contractor must be followed. These safety procedures will take precedence over any information contained in this document.